Postal Lock/Autocall/Exit/Door Sensor Devices; Postal Lock Switch; Autocall Device - Chamberlain Elite EL2000 Programming Manual

Postal Lock/Autocall/Exit/Door Sensor Devices

When a postal carrier triggers a postal lock switch, the assigned door number's relay will activate. The
postal entry door should be near the postal lock switch. Once the postal input is detected then the
relays for the door activate for their programmed time. They do not stay active if postal input remains
Factory Setting: Door 1
triggered.
Press Then
1
Enter Door Number to be Opened (0-4, 0=No Postal Lock). Then (#)
2
Example:
Assigns Postal Lock Switch to "Door 2".
Factory Settings: Door 1 activates Relay 1, Door 2 activates Relay 2, Door 3
The Autocall device calls the resident and can activate specific relays (a light or a buzzer)
Press Then
1
Enter Relays to be Activated (0000-1111). Then (#)
2
0=Deactivate, 1=Activate (1st digit=Relay 4, 2nd digit =Relay 3, etc.)
Example:
When a loop detector type device is triggered, only Relay "3" will activate.
Press *** and the 6-Digit Password (2 short beeps will be heard)
Exiting programming mode allows changes to take effect
Important: The Pound Key (#) must be used as Data Field Separator and to Save Data at the end of the
sequence. Time must be entered using a 24-hour format (8AM=0800, 3PM=1500 etc.). Audio Feedback:
Programming input is valid. Audio Feedback: Input is not valid. If you make an error during an entry,
press the asterisk key (*) to begin again.

Postal Lock Switch

1 2
activates Relay 3, Door 4 activates Relay 4

Autocall Device

Relay 4 Relay 3 Relay 2 Relay 1
1
Deact
To enter programming mode from the unit
Page 64
60
NOTE: A "Door Number" is
an external access control
device where the postal
carrier can gain entry.
Important: Whatever you
assigned Your Door
Settings applies to this
setting.
See page 25.
70
2
Activate Deact Deact