Wiring A Gate Operator (Normally Open); Wiring An Auto-Call Sensor - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION

WIRING A GATE OPERATOR (NORMALLY OPEN)

The gate operator can be connected to Relay 1 or Relay 2. See the Programming section for information about configuring
Relays 1 and 2.

WIRING AN AUTO-CALL SENSOR

The Auto-Call feature will enable the unit to contact the resident
when a driveway sensor (or any device that provides a contact
closure) is activated.
INSTALLATION
COM
(Common)
NO
(Normally Open)
TESTING
• Wire connectors can be removed to simplify
wiring.
• DO NOT overload wire connectors. Use
ONLY one wire per hole.
NO
(Normally Open)
7
PROGRAMMING
Primary Gate
Operator
(Strike Open Input)
Loop
Detector
Loop Sensor