Testing; Test The Gate/Door Relays; Test The Telephone Connections; Programming - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION
TEST GATE/DOOR RELAYS
TEST RELAY 1
Enter 4 digit Master Code + 1 (Key). The "1" Key indicates
the Relay to be triggered.
NOTE: Relay 1 status indicator LED will illuminate (Blue) to show
activity when triggered.
TEST RELAY 2
Enter 4 digit Master Code + 2 (Key). The "2" Key indicates
the Relay to be triggered.
NOTE: Relay 2 status indicator LED will illuminate (Blue) to show
activity when triggered.

TEST THE TELEPHONE CONNECTIONS

1. Place a telephone call from the resident's telephone to verify it
is operating properly, then hang up the phone.
NOTE: To ensure proper function of the audio and
authorization tones, keep the telephone handset at least 10 feet
from the EL1SS during testing.
2. Press the "Call" key on the unit's keypad. The telephone in the
residence should ring.
NOTE: After the "Call" Button is pressed, the "Status" LED on the
processor board will blink during transmission.
3. To test Relay 1 have someone answer the telephone and enter
"*9" (Star + 9). The EL1SS will disconnect the call as soon as
the relay is activated. To test Relay 2 have someone answer
the telephone and enter "*5" (Star + 5). The EL1SS will
disconnect the call as soon as the relay is activated.
INSTALLATION
? ? ? ? + 1
? ? ? ? + 2

TESTING

13

PROGRAMMING

Call Button