Wiring A Gate Operator (Normally Open); And A Door Strike Lock (Normally Open) - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION
WIRING A GATE OPERATOR
(NORMALLY OPEN) & A DOOR
STRIKE LOCK (NORMALLY OPEN)
The door strike can be connected to Relay 1 or Relay 2. See
the Programming section for information about configuring
Relays 1 and 2.
AC or DC
Power
NOTE: For DC power
install a 1N4001 diode
or equivalent.
INSTALLATION
Door Strike
NOTE: Do not use
the unit's power supply
for the door strike.
NOTE: For AC power install a
Siemens S10K30 MOV
(Metal Oxide Varistor) or equivalent.
COM (Common)
NO (Normally Open)
TESTING
NO
COM
(Normally Open)
(Common)
8
PROGRAMMING
• Wire connectors can be
removed to simplify wiring.
• DO NOT overload wire
connectors. Use ONLY one
wire per hole.
Primary Gate Operator
(Strike Open Input)