Code Setup; Code Operation - Chamberlain EL1SS Installation And Programming Manual

INTRODUCTION
ADJUST RELAY OUTPUT TIME (RELAY 2)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Output Time (in seconds):
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (2 hours & 13 minutes, Maximum)

CODE SETUP

The unit's Master Code is for owner/administrator level
commands. The User Codes allow users to activate and latch
relays 1 and 2 and to transmit radio commands on channels one
and two.
NOTE: The User Code cannot be the same as the Master Code.
ENTER A USER CODE NUMBERS
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter New User Code:
4. Enter the Relay/Channel for the Code to control:
2 or no button is pressed.
NOTE: If no button is pressed in step 4, both
relays/channels will activate simultaneously, when in
parallel mode.

CODE OPERATION

MASTER CODE OPERATIONS
TRIGGER RELAY 1 (ONLY)
Enter the Master Code:
NOTE: Requires Relay 2 be in Independent Mode.
ENABLE VACATION (LOCK DOWN) MODE
Locks the system from all User Code activity.
1. Enter the Master Code:
2. Enter the Program Code:
INSTALLATION
? ? ? ?
0 2 5
? ? ?
? ? ? ? The unit will
9 The unit will beep.
? ? ? ?
? ? ? ?
5 2
TESTING
DISABLE VACATION (LOCK DOWN) MODE
1. Enter the Master Code:
2. Enter the Program Code:
?
TRIGGER RELAY 1 AND CHANNEL 1
1. Enter the Master Code:
2. Enter the Program Code:
TRIGGER RELAY 2 AND CHANNEL 2
1. Enter the Master Code:
2. Enter the Program Code:
USER CODE OPERATIONS
TRIGGER PROGRAMMED RELAY/CHANNEL FOR USER CODE
Enter the User Code:
Relay/Channel will activate.
DELETE USER CODE NUMBERS
1 or
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter User Code to be deleted:
ENTER A TEMPORARY (1 SHOT) USER CODE NUMBER
The EL1SS holds 1 temporary User Code.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Temporary User Code:
4. Enter the Relay for the Code to control:
button is pressed.
NOTE: If no button is pressed in step 4, both relays will
activate simultaneously. Expires in 24 hours or after
fi rst use.
15
PROGRAMMING
? ? ? ?
5 3
? ? ? ?
1
? ? ? ?
2
? ? ? ? The appropriate
? ? ? ? The unit will
The unit will beep.
7
? ? ? ?
The unit will beep.
5 1
1 or 2 or no