Chapter 9: Port Parameters
Displaying Threshold Limit Settings on Ports
184
To display the threshold settings for the ingress packets on the ports, use
the SHOW STORM-CONTROL command in the Privileged Exec mode.
Here is the format:
show storm-control [
This example of the command displays the broadcast, multicast and dif
levels on ports 18:
awplus# show storm-control port1.0.18
Here is an example of the information the command displays.
Port
Bcastlevel
port1.0.18
Figure 43. SHOW STORM-CONTROL Command
The columns are described in Table 15 on page 227.
If the parameter port is not specified, the command displays the threshold
settings on all the ports on the switch.
If you want to display information on multiple ports at a time, enter:
awplus# show storm-control port1.0.18,port1.0.20,port1.0.21
Here is an example of the information the command displays.
Port
Bcastlevel
port1.0.18
Port1.0.20
port1.0.21
Figure 44. SHOW STORM-CONTROL Command
port
]
Mcastlevel
30
100
Mcastlevel
30
100
100
50
100
100
Diflevel
100
Diflevel
100
100
100