Lancom 1723 VOIP User Manual page 39

LANCOM 1722 VoIP – LANCOM 1723 VoIP – LANCOM 1724 VoIP – LANCOM 1823 VoIP
Chapter 2: Installation
³
Online The online LED displays the general status of all WAN interfaces:
Off
Green
Green
Green
Red
Orange/
green
Orange /
red
·
Connection status at the ADSL connector:
ADSL
Off
Orange
Orange
Orange
Orange
Orange
Orange
Red
Green
Green
Red/
orange
38
No active connection
Flashing Opening the first connection
Inverse flashing Opening an additional connection
On (perma- At least one connection is established
nently)
On (perma- Error establishing the last connection
nently)
In the housing At least one WLAN module is in managed mode and has not
cover; blinking found a WLAN Controller yet. The corresponding WLAN mod-
alternately with ule(s) is/are switched off until a WLAN Controller is found to
the power LED supply a configuration, or until being switched manually into
another operating mode.
In the housing At least one WLAN module is in managed mode and has
cover; blinking found a WLAN Controller. However, the WLAN Controller
alternately with cannot assign a configuration because the firmware and/or
the power LED the device's loader version is not compatible with the WLAN
Controller.
Interface deactivated
Blinking Initialization (establishing contact to provider)
Flashing Opening the first connection
Inverse flashing Opening an additional connection
On (permanently) At least one logical connection is established
Flickering Data traffic (send or receive)
Flashing Error (CRC error, framing error, etc.)
On (permanently) No synchronization, searching for remote station
Permanently Synchronization successful
Blinking/flashing Handshake/training
Blinking Hardware error