Lancom 1723 VOIP User Manual page 38

LANCOM 1722 VoIP – LANCOM 1723 VoIP – LANCOM 1724 VoIP – LANCOM 1823 VoIP
Orange/green
Orange /red
Red

The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click) Reset charge and time limits. The charge
settings are defined in LANconfig under Management
able if the 'Complete configuration display' is activated under Tools
With WEBconfig, charge protection and all parameters are to be found under LCOS menu tree
Setup Charges
In the housing
cover; blinking
alternately with
the online LED
In the housing
cover; blinking
alternately with
the online LED
blinking
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the con-
figuration data in the LANCOM is unprotected. Normally you would
set a configuration password during the basic configuration (instruc-
tions in the following chapter). Information about setting a configu-
ration password at a later time is available in the section 'The Security
Wizard'.
Reset budgets.
At least one WLAN module is in managed mode and
has not found a WLAN Controller yet. The correspond-
ing WLAN module(s) is/are switched off until a WLAN
Controller is found to supply a configuration, or until
being switched manually into another operating mode.
At least one WLAN module is in managed mode and
has found a WLAN Controller. However, the WLAN
Controller cannot assign a configuration because the
firmware and/or the device's loader version is not com-
patible with the WLAN Controller.
Time or charge limit on online connections has been
reached
Costs (these settings are only avail-
Chapter 2: Installation
Signal that a
charge or time
limit has been
reached
Options).
37