Nokia 6680 RM-36 Service Manual page 84

Nokia Customer Care
After the drivers are installed and if there are problems, check that the USB connection is active from
the Windows Control Panel or contact the local PC support.
iii For an FPS-8 flash prommer, choose the following connection settings:
• Media: FPS-8
• Port Num: COM Port where FPS-8 is connected
• COMBOX_DEF_MEDIA: FBUS
iv For a plain USB connection choose the following connection settings:
Note: First connect the DKU-2 USB cable between the PC USB port and phone.
• Media: USB
Note: When the phone is connected to a PC for the first time, allow the PC to install the USB device
drivers first.
Please note that this may take some time to complete.
After the drivers are installed and if there are problems, check that the USB connection is active from
the Windows Control Panel or contact the local PC support.
5. To complete the configuration, click Finish.
If you are using the Wizard, connect the tools and a phone to your PC and the wizard will automatically try
to configure the correct connection. Please note that this may take time because Phoenix will go through
all connections on the PC.
6. Click the connection you want to activate and use up/down arrows to move it on top of the list, then click
Apply.
The connection is now selected and can be used after closing the Manage Connections window.
The selected connection is shown on the right hand bottom corner of the screen.
Page 3–18
Figure 21 Connections list
Figure 22 Connection information
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Service Software Instructions
RM-36
Issue 1