Nokia 6680 RM-36 Service Manual page 83

RM-36
Service Software Instructions
3. To add a new connection, click Add, and select if you want to create it manually or by using the Connection
Wizard.
In the following dialogs you are asked to select settings for the connection. If you use the Wizard, connect
the tools and a phone to your PC and the wizard will automatically try to configure the correct connection.
4. Select Manual mode, and click Next to continue.
i For an FPS-10 flash prommer with a USB Connection, choose the following connection settings
• Media: FPS-10 USB
• Device Index: 0
• Serial Num: See Serial No from the label attached to the bottom of your FPS-10
• Active Media: USB
ii For an FPS-10 flash prommer with a LAN connection, choose the following connection settings
• Media: FPS-10 TCP/IP
• Net Serv Name: Select "Scan". Choose your own FPS-10 device based on the correct MAC address. See
Serial No from the label attached to the bottom of your FPS-10.
• Port Num: Use default value, click "Next".
• Protocol Family: Use default value, click "Next".
• Socket Type: Use default value, click "Next".
• TX Buffer Size: Use default value, click "Next".
• RX Buffer Size: Use default value, click "Next".
Note: When the phone is connected to a PC for the first time, allow the PC to install the USB device
drivers first.
Please note that this may take some time to complete.
Issue 1
Figure 20 Select mode: Manual
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Nokia Customer Care
Page 3–17