Back-Up Battery Interface Connections And Electrical Characteristics; Rf Description; Receiver; Introduction To Receiver Functionality - Nokia 6680 RM-36 Service Manual

Nokia Customer Care

Back-up battery interface connections and electrical characteristics

Pin name I/O
L2207, VBack ->
Description Parameter
Back-Up Vback
Battery Voltage

RF description

Receiver

Introduction to receiver functionality

Receiver functions are implemented in RF ASIC N7501.
The receiver is a linear direct conversion receiver consisting of separate front ends (LNA and demodulator) for
each supported system.
After the demodulators, the signal paths are combined to one common BB path.

WCDMA receiver

In the WCDMA mode, the received signal is fed from the antenna to the duplex filter. After the duplex filter the
signal goes via balun to the integrated LNA residing in N7501. After the LNA, the signal goes trough an off chip
band pass SAW filter. The main task of the filter is to attenuate the Tx signal which is leaking trough the duplex
filter and amplified by LNA.
After filtering, the signal goes to the down conversion mixer, which converts the signal into baseband I and Q
signals (90 degrees phase shift). After the demodulator output there is a RC low pass filter with f0 of ca. 1.5
MHz. It is effectively part of the BB selectivity filtering.
At BB frequency the signal is amplified and fed to a low pass filter giving the selectivity of the receiver. The
filters need RC constants, which suffer of process variations. Therefore the integrated resistors are adjustable
by digital control word.
Rx channel filter must be calibrated with automatic routine whenever N7501 IC is changed to a phone.
In the WCDMA mode, the corner frequency of the filter is set to ca. 2.1MHz. The filter is followed by an AGC
amplifier with adjustable gain. Signal is further amplified before it is fed to balanced analogue IQ output pins.
Analogue output pins are accompanied by reference voltage output, which sets the DC level for the AD converter
in BB ASIC RAP3G.
The gain of the Rx chain can be adjusted in multiple phases. The first adjustable gain is in LNA which has low,
mid and high gain settings and isolation mode. After the mixer, there are adjustable gains (AGC) inside the
N7501 IC.
Page 9–46
Table 35 Back-up battery connections
Connection
Retu, VBack
Table 36 Back-up battery electrical characteristics
Min
0
Company Confidential
Copyright ©2005 Nokia. All Rights Reserved.
Notes
Back-up battery G2200 is connected to RETU via
coil
Typ Max
2.5 2.7
RM-36
System Module
Unit
V
Issue 1