Fanvil i20S User Manual page 35

[键入文字]
Listener configuration
 Blue part (name)
"Group 1","Group 2" and "Group 3" are your setting monitoring multicast name.The group name will
be displayed on the screen when you answer the multicast. If you have not set, the screen will display the
IP: port directly.
 Purple part (host: port)
It is a set of addresses and ports to listen, separated by a colon.
 Pink part (index / priority)
Multicast is a sign of listening, but also the monitoring multicast priority. The smaller number refers to
higher priority.
 Red part (priority)
It is the general call, non multicast call priority. The smaller number refers to high priority. The
followings will explain how to use this option:
 The purpose of setting monitoring multicast "Group 1" or "Group 2" or "Group 3" launched a multicast
call.
 All equipment has one or more common non multicast communication.
 When you set the Priority for the disable, multicast any level will not answer, multicast call is rejected.
 when you set the Priority to a value, only higher than the priority of multicast can come in, if you set
the Priority is 3, group 2 and group 3 for priority level equal to 3 and less than 3 were rejected, 1
priority is 2 higher than ordinary call priority device can answer the multicast message at the same
time, keep the hold the other call.
 Green part (Enable Page priority)
Set whether to open more priority is the priority of multicast, multicast is pink part number. Explain
how to use:
 The purpose of setting monitoring multicast "group 1" or "3" set up listening "group of 1" or "3"
multicast address multicast call.
 All equipment has been a path or multi-path multicast phone, such as listening to "multicast
information group 2".
35
/ 50