Fanvil i20S User Manual page 26

[键入文字]
Enable DND
Blocking Anonymous
Call
Use 182 Response for
Call waiting
Anonymous Call
Standard
Dial Without Registered Set call out by proxy without registration
Click To Talk
User Agent
Use Quote in Display
Name
Ring Type
Conference Type
Server Conference
Number
Transfer Timeout
Enable Long Contact
Enable Missed Call Log
Response Single Codec
Use Feature Code
Specific Server Type
Registration Expiration
Use VPN
Use STUN
Convert URI
DTMF Type
DTMF SIP INFO Mode
Transportation Protocol Set the line to use TCP or UDP for SIP transmission
SIP Version
Enable Do-not-disturb, any incoming call to this line will be rejected
automatically
Reject any incoming call without presenting caller ID
Set the device to use 182 response code at call waiting response
Set the standard to be used for anonymous
Set Click To Talk
Set the user agent, the default is Model with Software Version.
Whether to add quote in display name
Set the ring tone type for the line
Set the type of call conference, Local=set up call conference by the device
itself, maximum supports two remote parties, Server=set up call conference by
dialing to a conference room on the server
Set the conference room number when conference type is set to be Server
Set the timeout of call transfer process
Allow more parameters in contact field per RFC 3840
If enabled, the phone will save missed calls into the call history record.
If setting enabled, the device will use single codec in response to an incoming
call request
When this setting is enabled, the features in this section will not be handled by
the device itself but by the server instead. In order to control the enabling of
the features, the device will send feature code to the server by dialing the
number specified in each feature code field.
Set the line to collaborate with specific server type
Set the SIP expiration interval
Set the line to use VPN restrict route
Set the line to use STUN for NAT traversal
Convert not digit and alphabet characters to %hh hex code
Set the DTMF type to be used for the line
Set the SIP INFO mode to send '*' and '#' or '10' and '11'
Set the SIP version
26
/ 50