Percentage Weighing - Adam Equipment NBL 84 e/i Operating Manual

EN
10.4.2

Percentage Weighing

Percent weighing will be done by defining a certain weight to be 100%. The weight to be
used can either be entered by the user or taken from a sample
Press [Mode] and then the [Up] or [Down] key until the "
enter percent weighing mode by pressing [Setup].
Display will show, "SAmmPLE
Press the [Up] or [Down] keys to toggle between the two methods and press [Setup] to
select the desired method.
10.4.2.1
%
When "SAmmPLE SAmmPLE SAmmPLE SAmmPLE " is displayed, press [Setup].
LOAd" followed by 100
When "LOAd LOAd LOAd
[Setup] to set this weight to be 100%. The display will show "REF WT
weight in the last selected unit. After a short pause, "100
be shown on the top of the display to indicate that the balance is in the percent weighing
mode
Remove the sample and "0 0 0 0 .00
Now place an unknown sample on the pan to display the percentage weight relative to the
original sample.
To set another weight as 100%, press [Mode] and repeat as before.
10.4.2.2
To manually enter a value to be set as 100%, when "Ent Wt
The display will briefly show "100 Wt
weighing mode.
Change the displayed weight to the required sample weight using the direction keys and
numeric entry method and press [Setup] to enter the value. The display will now return to
zero.
Now place unknown samples on the pan to display the percentage weight relative to the
set sample weight.
To repeat percent weighing with another sample press [Mode] and continue as before, or
to return to normal weighing mode, press [Mode] followed by [
NOTE: Percentage will be initially displayed to the maximum number of decimal places
based on the resolution of the balance. To increase or decrease by one decimal place,
press the [Up] or [Down] key respectively.
© Adam Equipment Company 2015
%
SAmmPLE SAmmPLE SAmmPLE " (sample method) or "Ent Wt
Sample method:
%
100
100 100 " is shown, carefully add the sample to the pan. Now press
%
00 00 00 " will be displayed
Manual method:
100 Wt" followed by a weight value in the unit last used in the
100 Wt 100 Wt
Percent
" symbol is displayed. Now
%
Ent Wt Ent Wt Ent Wt " (manual weight method).
REF WT" and the sample
REF WT REF WT
%
100 " will be displayed. "
100 100
%
Ent Wt Ent Wt Ent Wt " is displayed, press [Setup].
0/T].
22
3016612481Rev2.00-Jul15
Percent
" will