Percentage Weighing; Check Weighing - Adam Equipment LBX 12 User Manual

•
Press the [Tare/↵] key once the stability indicator comes on to confirm the
entered value. The display will show the number of pieces placed on the pan.
•
If more items are put on the pan, the increased count value will be shown.
•
Press [FUNC/ ↑ ] to exit and go back to the normal weighing mode.

5.3.2 PERCENTAGE WEIGHING

•
In the weighing mode, press [FUNC/ ↑ ] until the display shows "PER".
•
Press the [Tare/↵] key to set the reference sample value, the display will
show "SET".
•
Place the item to be set at 100% on the pan and press the [Tare/↵] Key when
the stability indicator comes on.
•
The display will show "
•
When another item with a different weight value is put on the pan, the
relative % value would be shown against the initial reference sample value.
•
Press the [FUNC/ ↑ ] key to exit and go back to weighing mode.

5.3.3 CHECK WEIGHING

•
When in normal mode, press [FUNC/ ↑ ] until the display shows "CHECK".
•
Press [Tare/↵] to set the high limits. The display will show the "000000" with
one digit flashing and the 'HI' LED lit.
•
Press [FUNC/ ↑ ] to increase the flashing digits;
•
Press [UNITS/ → ] to select the digit;
•
Press [Tare/↵] to accept the value and move to set the low limits. The display
will show "000000" with one digit flashing and the 'LO' LED lit.
•
Use the same method the set the low limits and press [Tare/↵] to enter the
buzzer setting section,
•
Press [FUNC/ ↑ ] to change the display to "BP INT" or "BP OUT" or "BP OFF"
to have beeper sound when the weight is outside the limits, between the
limits or off.
•
Press [Tare/↵] to start the check weighing.
•
Put the item on the pan, if the weight is below the low limits set, the scale
will show "xxxxx.x" with the 'LO' LED lit; if it is higher than the high limits set,
© Adam Equipment Company 2018
. %".
6