Zoom X3 User Manual page 44

•
If you are using Mac OS X 10.3 and above, renew your IP
address: Point to System Preferences, then choose Network.
Click the Configure button and then the Renew DHCP
Lease button.
•
If you are using a Windows computer, perform a
Release/Renew operation:
Windows 2000/XP: From the desktop, click the Start
button, then point to Programs, point to Accessories,
and then select Command Prompt. Type ipconfig /all
and press the Enter key on your keyboard. In the
subsequent dialog box, make sure the NIC adapter is
listed, click Renew and then click Release. Then type
192.168.1.1 into your browser's address bar, and the
Network Password box should display.
For Windows 95/98/Me: From the desktop, click the
Start button and the point to Run. Type winipcfg, and
click OK. In the subsequent dialog box, make sure the
NIC adapter is highlighted in the drop-down list, click
Renew and then click Release. Then type 192.168.1.1 into
your browser's address bar, and the Network Password
box should display.
Problem
The computer on which I installed the X4 software is connected to
the Web, but the computers connected through my network device
cannot access the Internet.
Solution
The problem is most likely with your network device (such as a
wireless access point, router, hub, or switch). Check these items:
•
Try rebooting each computer on your network. For example, if
you are using a router, reboot each computer that is connected
to the router. This will allow for the computers to release and
renew their IP addresses.
•
If you are using a wireless access point or a router, verify that
the device is using Dynamic Host Configuration Protocol
(DHCP). This is also known as dynamic IP addressing.
44