Zoom X3 User Manual page 10

Step 3: Establishing
Communication
Important!
Mac users must make sure that the computer's TCP/IP settings are
configured properly BEFORE starting this section. See Macintosh
TCP/IP Settings.
1
Open your Web browser, enter 192.168.1.1 in the address bar,
and press the Enter key to open the modem configuration
pages.
2
In the Authentication Required dialog box, type the following
User Name and Password in lower case, then click OK.
User Name: admin
Password: zoomadsl
3
The Zoom Configuration Manager opens and displays its
Basic Setup page.
4
You may choose to use either the Automatic Configuration
option or manually enter information provided by your service
provider in the Basic Setup page. We recommend using the
Automatic Configuration option. (If you are using a static IP
address, you must manually enter information to establish
communication.)
If you choose to manually enter information, please go to the
next section, which is called Read This Only if Your Are
Manually Entering Information Into the Basic Setup Page.
If you would like to use the Automatic Configuration option,
please go to step 5 below.
5
Click on Start under Automatic Configuration. It may take up
to 2-3 minutes to detect your connection.
6
If a PPPoE or PPPoA connection is detected, enter the
username and password provided by your service provider for
PPPoE or PPPoA protocols. (Your provider should have given
10