Zoom X3 User Manual page 12

d
If you selected PPPoE or PPPoA as your
Protocol, your provider should have given you a
User ID or User Name (usually your email
address or the characters preceding the @ sign in
your email address) and a Password. (These are
NOT the User ID and Password that you used to
get into the Basic Setup menu.)
e
If you cannot remember or cannot find your User
ID and Password, call your service provider and
ask for them. Then enter them in the appropriate
boxes. This information is required for PPPoE
and PPPoA protocols.
f
If you selected 1483 Bridged IP+NAT or 1483
Routed IP as your Protocol, the X3 or X4 can be
set for either a Dynamic Host Configuration
Protocol (DHCP) address (also known as a
dynamic IP address) or for a static IP address.
g
Because most Internet service providers use
DHCP, the X3 and X4 are set for dynamic IP
addressing by default.
h
Only advanced users who specifically want to use
static IP addressing and/or those users whose
Internet service provider specifically instructed
them to use static IP addressing should change
this setting. Your provider should have given you
four series of numbers for the IP (Internet
Protocol) Address, Subnet Mask, Gateway,
and DNS. Enter these numbers in the
appropriate boxes, and select Use the Following
IP Address.
i
Click Save/Reboot.
j
Your modem should now be properly connected.
To test your installation, open your browser and
go to a familiar Web site. If your browser works,
installation is complete for the computer you used
12