Connecting A Networkd; Evice - Zoom X3 User Manual

Connecting a Network Device
If you want to connect your X3 or X4 to only one computer,
please go to chapter 3 now. If you want to connect the X3 or X4
to a network device such as a wireless access point or a switching
hub, please continue reading chapter 2 below.
This section provides general instructions for connecting a network
device to the X3 or X4. For information about setting up your
network device, please refer to the documentation that came with
that device.
1
Once you have configured the X3 or X4, you can disconnect
the Ethernet cable from the computer.
Ethernet cable should still be plugged into the LAN port of
the X3 or X4.
2
Plug the other end of the Ethernet cable into the network
device's Ethernet port. (For a hub or a switch, this is typically
called an Uplink or Expansion port. For a router or wireless
access point, this is typically called a WAN port.)
3
Set up your network. Refer to the documentation provided
with your particular network device for instructions on how to
do this.
4
Once your network is set up, reboot any computer that is part
of the network. For example, if you are connecting a wireless
access point, reboot any computer that will use the wireless
network.
5
Verify that your Internet connection is working. Open the
Web browser (e.g., Internet Explorer or Mozilla Firefox) on
Chapter 3: Status Monitoring
2
One end of the
15