Network Configuration; Ip Configuration Method; Picture 66: Ip Configuration Method; E.4.2 Network Configuration - Image Access Wide Tek WT 36C Setup Manual

E.4.2

Network Configuration

The section Network Configuration
The Network Configuration start screen is the IPv4 (Network Interface 0) screen, which
is described in chapter E.4.2.2. The following description starts with the IP Configuration
Method screen.
E.4.2.1 IP Configuration Method
The function

IP Configuration Method

methods of IP configuration of the scanner.
Manual Allows setting the IP address, subnet mask, and default gateway manually;
corresponding to the network where the scanner will be used.
After modifying the above named values, the connection to the scanner
must be restored with the new data.
DHCP
Sets the values for IP address, subnet mask, and default gateway
automatically, depending on the existing network where the scanner is
installed.
A DHCP server must be accessible in the network. For detailed
information, ask the network administrator of the local network before
selecting the DHCP method.
When selecting DHCP the connection to the scanner is lost. The
connection to the scanner must be restored with the new data.
Important for the next steps:
After changing the network settings, enter the new IP address of the scanner in your
browser and reopen the Poweruser main menu as previously described.
Setup Manual
is divided in subsections.
allows the operator to select between two

Picture 66: IP Configuration Method

Page 71