Hirschmann RS20 Reference Manual page 106

CLI Commands: Base
<refresh-interval>.
Configure the IO-Module event logging for one or all digital outputs.
all Configure the IO-Module event logging for all digital outputs.
<slot/output>
single digital output.
disable Disable event logging for digital output status changes.
enable
snmp-trap
This command enables or disables the sending of SNMP traps in
case of output status changes for one or all digital outputs. Default:
disable.
The trap will be sent to all SNMP trap receivers configured with
snmptrap.
The output state will be checked according to the interval set with IO-
<refresh-interval>.
all Configure the IO-Module SNMP trap for all digital outputs.
<slot/output>
digital output.
disable Disable SNMP traps for digital output status changes.
enable
106
Configure the IO-Module event logging for a
Enable event logging for digital output status changes.
Configure the IO-Module SNMP trap for a single
Enable SNMP traps for digital output status changes.
4.6 Management Commands
Release 7.0 05/2011
CLI L2P