Installation-Air To Oil Cooler; Installation - Dodge dakota 2002 Service Manual

DR
TRANS COOLER - 5.9L DIESEL (Continued)
Fig. 6 Auxiliary Transmission Oil Cooler—Diesel
1 - MOUNTING BOLTS
2 - RADIATOR
3 - QUICK-CONNECT FITTINGS
4 - TRANSMISSION OIL COOLER
(5) Disconnect transmission oil lines from cooler.
Plug cooler lines to prevent oil leakage.
(6) Remove cooler bracket to transmission bolt.
(7) Remove two cooler bracket to cooler bolts.
(8) Remove cooler assembly from vehicle. (Fig. 7)

INSTALLATION

INSTALLATION—AIR TO OIL COOLER
(1) Carefully position the oil cooler assembly to the
vehicle.
(2) Install two nuts and one bolt. Tighten to 11
N·m (95 in. lbs.) torque.
(3) Connect the quick-connect fittings to the trans-
mission cooler lines.
(4) Install Charge Air Cooler (Refer to 11 -
EXHAUST SYSTEM/TURBOCHARGER SYSTEM/
CHARGE AIR COOLER
INSTALLATION).
(5) Start the engine and check all fittings for
leaks.
Engine
AND PLUMBING
Fig. 7 Transmission Water-To- Oil Cooler—Diesel
1 - TRANSMISSION WATER-TO-OIL COOLER
(6) Check the fluid level in the automatic trans-
mission (Refer to 21 - TRANSMISSION/TRANS-
AXLE/AUTOMATIC - 47RE/FLUID - STANDARD
PROCEDURE).
INSTALLATION
(1) Position oil cooler on cylinder block.
(2) Install two mounting bolts to cooler at the cyl-
inder block. Torque bolts to 77N·m (57 ft. lbs.)
(3) Install cooler bracket to transmission adapter
bolt. Tighten to 24N·M (18 ft. lbs.).
(4) Connect transmission oil lines to cooler.
(5) Connect coolant hoses to cooler.
(6) Install starter motor (Refer to 8 - ELECTRI-
CAL/STARTING/STARTER MOTOR - INSTALLA-
TION).
(7) Connect battery negative cables.
(8) Fill cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
(9) Check transmission oil level and fill as neces-
sary (Refer to 21 - TRANSMISSION/TRANSAXLE/
- AUTOMATIC -
PROCEDURE).
TRANSMISSION
47RE/FLUID - STANDARD
7 - 75