Removal - Except V-10 Or Diesel Engine; Removal - V-10 Or Diesel Engine - Dodge dakota 2002 Service Manual

8R - 16 WIPERS/WASHERS
WASHER RESERVOIR (Continued)
REMOVAL

REMOVAL - EXCEPT V-10 OR DIESEL ENGINE

(1) Unlatch and open the hood.
(2) Disconnect and isolate the battery negative
cable.
(3) Remove the fasteners securing the coolant
recovery container or the coolant pressure container
to the top of the cooling module and move the con-
tainer aside. It is not necessary to open or drain the
engine cooling system. (Refer to 7 - COOLING/EN-
GINE/COOLANT RECOVERY
REMOVAL) or (Refer to 7 - COOLING/ENGINE/
COOLANT RECOVERY PRESSURE CONTAINER -
REMOVAL).
(4) Disconnect the reservoir washer hose from the
barbed nipple of the inline fitting at the engine com-
partment washer hose in the right headlamp and
dash wire harness and allow the washer fluid to
drain from the reservoir into a clean container for
reuse (Fig. 15).
Fig. 15 Washer Reservoir Remove/Install
1 - TOP TAB
2 - RADIATOR SHROUD
3 - TOP SLOT
4 - RIGHT HEADLAMP & DASH WIRE HARNESS
5 - ENGINE COMPARTMENT WASHER HOSE
6 - BOTTOM SLOT (2)
7 - RESERVOIR WASHER HOSE
8 - BOTTOM TAB (2)
9 - WASHER FLUID LEVEL SWITCH
10 - WASHER PUMP/MOTOR
11 - WASHER RESERVOIR
12 - LOCK FEATURE
harness connector for the washer fluid level switch
from the switch connector receptacle.
harness connector for the washer pump/motor unit
from the motor connector receptacle.
firmly with both hands and pull the unit sharply
upward to disengage the locking feature on the
washer reservoir from the depression in the radiator
shroud.
CONTAINER -
far enough to disengage the three mounting tabs (one
at the top and two at the bottom) from the channel-
like slot at the top and the two slots at the bottom of
the radiator shroud.
side of the engine compartment.

REMOVAL - V-10 OR DIESEL ENGINE

cable.
integral routing clips on the top of the radiator fan
shroud (Fig. 16).
1 - WIRE HARNESS
2 - WASHER RESERVOIR
3 - WASHER PUMP/MOTOR
4 - WASHER HOSE
5 - WASHER FLUID LEVEL SWITCH
(5) Disconnect the right headlamp and dash wire
(6) Disconnect the right headlamp and dash wire
(7) Grasp the bottom of the washer reservoir
(8) Continue lifting the washer reservoir upward
(9) Remove the washer reservoir from the right
(1) Unlatch and open the hood.
(2) Disconnect and isolate the battery negative
(3) Disengage the reservoir washer hose from the
Fig. 16 Washer Reservoir Connections - V-10 &
Diesel Engine
DR