Dodge dakota 2002 Service Manual page 584

Table of Contents

Advertisement

DR
DRIVER DOOR MODULE (Continued)
Fig. 3 Driver Door Module Connector C2 Receptacle
DRIVER DOOR MODULE SWITCH TESTS
POWER LOCK SWITCH
SWITCH POSITION
NEUTRAL
LOCK
UNLOCK
POWER MIRROR SWITCH
SWITCH POSITION
LEFT MIRROR SELECTED
UP
DOWN
RIGHT
LEFT
RIGHT MIRROR SELECTED
UP
DOWN
RIGHT
LEFT
POWER WINDOW SWITCH
SWITCH POSITION
NEUTRAL
LEFT FRONT UP
RESISTANCE BETWEEN
CONNECTOR C-1 PINS
7 & 11
10 KILOHMS ± 1%
820 OHMS ± 5%
330 OHMS ± 5%
CONTINUITY BETWEEN
PINS OF CONNECTOR
C-2
PINS 1 & 3
PINS 2 & 3
PINS 2 & 3
PINS 3 & 6
PINS 3 & 7
PINS 2 & 3
PINS 2 & 3
PINS 3 & 4
CONTINUITY BETWEEN
PINS OF CONNECTOR
C-1
PINS 1 & 8, PINS 2 & 8,
PINS 3 & 8, PINS 4 & 8,
PINS 5 & 8, PINS 6 & 8,
PINS 8 & 10, PINS 8 &
12
PINS 5 & 9
DRIVER DOOR MODULE SWITCH TESTS
LEFT FRONT DOWN
RIGHT FRONT UP
RIGHT FRONT DOWN
LEFT REAR UP
LEFT REAR DOWN
RIGHT REAR UP
RIGHT REAR DOWN
POWER WINDOW LOCKOUT SWITCH
SWITCH POSITION
OFF (SWITCH BUTTON
RAISED - NOT
DEPRESSED)
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the door trim panel (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
(3) Remove the driver door module from the trim
panel bezel.
INSTALLATION
(1) Install driver door module to trim panel bezel.
(2) Install door trim panel (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION).
(3) Connect battery negative cable.
REMOTE KEYLESS ENTRY
MODULE
DESCRIPTION
When an RKE lock message is sent to the instru-
ment cluster, the instrument cluster actuates the
door locks, the interior lighting is turned off, the
horn chirps (if this feature is enabled), the park
lamps flash (if this feature is enabled) and, if the
vehicle is so equipped, the Vehicle Theft Security
System (VTSS) is armed. When an RKE unlock mes-
sage is sent to the instrument cluster, the instrument
cluster actuates the driver side front door (or all
doors if this feature is enabled) unlock, the interior
lighting is turned on and, if the vehicle is so
equipped, the VTSS is disarmed.
When an RKE panic message is sent to the instru-
ment cluster, the instrument cluster actuates the
driver side front door (or all doors if this feature is
enabled) unlock, the interior lighting is turned on
and, if the vehicle is so equipped, the VTSS is dis-
armed. The panic message will also cause the exte-
rior lamps (including the headlights) to flash, and
POWER LOCKS
8N - 7
PINS 9 & 12
PINS 3 & 9
PINS 6 & 9
PINS 4 & 9
PINS 9 & 10
PINS 2 & 9
PINS 1 & 9
CONTINUITY BETWEEN
PIN 9 OF CONNECTOR
C-1 & PIN 8 OF
CONNECTOR C-2

Advertisement

Table of Contents
loading

Table of Contents