Polycom MGC-25 Release Notes page 38

MGC Release Notes - Version 9.0
Table 7: Corrections between Versions V.8.0 and V.9.0
#.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
34
Category Description
HD An HD endpoint is connected as
Secondary (audio only) when
connecting to a VSW conference
whose line rate is 1920Kbps and the
video parameters are fixed (disabling
the Highest Common mechanism).
HD Video freezes occur when a LifeSize
Team endpoint version 2.1 changes its
resolution from HD to QCIF.
HD Video artifacts are seen when an HDX
endpoint version 1.0.1 connects to an
HD Video Switching conference at a
line rate of 1920Kbps and H.264 video.
HD When a non-HD endpoint connects to
an HD Video Switching whose bit rate
is higher than 1152Kbps and the video
parameters are fixed (disabling the
Highest Common mechanism), the
HDX endpoint disconnects from the
conference.
Interop LifeSize ISDN endpoint "Room
ver2.1.3(5)" cannot connect to a
CP-Classic conference via dial-in or
dial-out.
Interop Tandberg endpoint version 5.2 is muted
unexpectedly by the MCU during calls.
Interop LifeSize endpoint Room Ver 2.1.3(5)
that does not support H.261 cannot
connect to MGC.
Interop An exception occurs when a Tandberg
endpoint version F6.0 defined as video
dial-in connects to the conference as
Audio only or when connected using
video protocol H.264 with Profile 0
(invalid H.264 Profile).
Interop A Tandberg endpoint is connected as
Secondary (audio only) when
connecting to a VSW conference
whose line rate is 1152Kbps and video
parameters set to automatic mode with
a connected HDX ISDN endpoint.
IP The IP48 card stops responding when
dialing in to COP target conference via
an Entry Queue.
ID# Remarks
VNGM-
1578
VNGM-
1665
VNGM-
1841
VNGM-
1661/
VNGM-
1594
VNGM -
1440/
VNGFE
-311
VNGM -
1717/
VNGFE
-330
VNGM -
1718/
VNGFE
-376
VNGM -
1917/
VNGFE
-574
VNGM-
1685
VNGM -
1725/
VNGFE
-466