Application Programs - Getting Started; Starting An Application Program - Leica GPS1200+ Applications Manual

1

Application Programs - Getting Started

1.1

Starting an Application Program

Access an applica-
tion program step-
by-step
XX Begin
Application Programs - Getting Started
Step Description
1. Press PROG. The PROG key opens the application programs menu
GPS1200+ Programs.
2. GPS1200+ Programs
Select an option in the menu.
3. CONT (F1) to access XX Begin.
Some application programs are protected. They are activated through a
specific licence key. This can either be typed in in Main Menu:
Tools...\Licence Keys or the first time the application program is started.
Four application programs can be open at one time. XX Begin is shown
for the application program opened first, but not for the following applica-
tion programs.
SURVEY Survey Begin is shown as an example. Additional fields are available for
particular application programs. The first screen of Wake-Up Sessions differs from
XX Begin and is explained in the chapter on Wake-Up Sessions.
Description of fields
Field Option
<Control Choicelist
Job:>
<Stakeout Choicelist
Job:>
<Job:> Choicelist
CONT (F1)
CONF (F2)
CSYS (F6)
Description
Available for Reference Line. The original points
to be staked and the reference lines/arcs are
stored in this job.
Available for Stakeout. The job containing the
points to be staked.
The active job.
For Stakeout and Reference Line: Points which
are occupied after staking out are stored in this
job. The original points to be staked are not
copied to this job.
GPS1200+
To accept changes and access the
subsequent screen.
To configure the application program.
To select a different coordinate
system. Not available for <Use Auto
CrdSys: Yes> configured in CONG-
FIGURE Additional Rover
Settings.
7