Table of Contents
Advertisement
23.2a Two screws (arrowed) in the front of
the motor . . .
Estate
7 Note that when removing the rear window
wiper arm, it will be necessary to detach the
washer hose from the spindle prior to
removing the wiper arm retaining nut (see
illustration).
23 Windscreen wiper motor and
linkage - removal and refitting
1 Remove the windscreen wiper arms as
described in the previous Section.
2 Undo the eight Torx screws which secure
the wiper motor and linkage to the bulkhead
(see illustrations).
23.3 Disconnecting the wiper motor multi-
plug
23.5 Undo the crank arm nut and the three
bolts (arrowed)
23.2b . . . three screws around the right-
hand spindle . . .
3 Disconnect the multi-plug and remove the
motor and linkage (see illustration).
4 The linkage arms can be removed by
levering them off the pivot pins.
5 To remove the motor, undo the crank arm
nut and remove the three securing bolts (see
illustration). The motor cover can then be
removed. A defective motor must be renewed.
6 Refit by reversing the removal operations.
Before refitting the wiper arms, switch the
wipers on and then off so that the motor takes
up the "parked" position.
24 Rear window wiper motor -
removal and refitting
1 Remove the rear wiper arm from the spindle.
2 Open the tailgate and remove the interior
trim panel, which is secured by eleven screws.
3 Remove the three bolts which secure the
wiper motor bracket to the tailgate (see
illustration). Also remove the screw which
secures the earth tag. Disconnect the wiring
plug and remove the motor and bracket.
4 The bracket can be unbolted from the motor
if wished. No spare parts for the motor are
available.
5 Commence refitting by offering the motor
and bracket to the tailgate. Secure the
assembly with the three bolts, then reconnect
the wiring and secure the earth tag.
6 Switch on the ignition and operate the rear
wiper control briefly so that the motor stops in
the "parked" position.
24.3 Three bolts secure the rear wiper
motor (two arrowed)
Body electrical system 13•17
23.2c . . . and two screws on the left.
Eighth screw is midway between the spindles
7 Refit the wiper arm and blade. Wet the
window and operate the rear wiper control
again to check the function of the motor.
8 Switch off the ignition and refit the tailgate
interior trim panel.
25 Windscreen, rear window and
headlight washer components
- removal and refitting
Windscreen and rear washer jets are
removed simply by prising or pulling them
from
their
locations
(see
Headlight washer jets can be unclipped from
their holders after disconnection of the high
pressure hose from the jet.
To remove a washer pump, first syphon out
the contents of the reservoir. Disconnect the
wiring and the hose from the pump, then pull
the pump out of its grommet in the reservoir.
Renew the grommet if necessary when
refitting the pump.
26 Fuel computer components -
removal and refitting
1 The fuel tank sender unit, EEC IV module
and speedometer sender unit are not peculiar
to the fuel computer. Their removal and
refitting procedures are given in Chapter 4,
Chapter 5 and this Chapter respectively.
25.1 A windscreen washer jet prised out of
its location in the bonnet
illustration).
13
Advertisement
Table of Contents
