Windscreen Washers; Checking The Wiper Blades; Changing The Wiper Blades; Windscreen Wiper Blades - Ford Ranger Owner's Manual

Adjust the sensitivity of the rain sensor
using the rotary control. With low
sensitivity, the wipers will operate when
the sensor detects a lot of water on the
windscreen. With high sensitivity, the
wipers will operate if the sensor detects a
small amount of water on the windscreen.

WINDSCREEN WASHERS

CAUTION
Operating this function with the
engine off will drain the battery.
WARNING
Do not operate the windscreen
washers for more than 10 seconds
or when the reservoir is empty.
Ranger (TKE) Vehicles Built From: 03-12-2012, Vehicles Built Up To: 31-12-2013
Wipers and Washers
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blade lips with water
applied with a soft sponge.
CHANGING THE WIPER
BLADES

Windscreen wiper blades

snow and ice. The windscreen wipers will
return to their normal position as soon as
you switch on the ignition so make sure
that the outside of the windscreen is free
from snow and ice before you switch on
the ignition.
40
CAUTIONS
Set the windscreen wipers in the
service position to change the wiper
blades.
You can use the service position in
winter to provide easier access to the
wiper blades for freeing them from