Table of Contents
Advertisement
3.14 Front foglight bulb renewal
A Rotating screws
C Alignment screw
B Spring clip
12 Connect the new bulb, fit it and secure it
with the spring clip.
13 Check the light for correct operation, then
refit and secure the cover.
Front foglight (when fitted)
14 Remove the lens and reflector together by
undoing the two retaining screws. Do not
disturb the alignment screw (see illustration).
15 Disconnect the wiring from the bulb.
Release the spring clip and extract the bulb.
Caution: If the lights have just been in use, the
bulb may be extremely hot.
16 Do not touch the glass of the new bulb
with the fingers.
17 Fit the new bulb and secure it with the
spring clip. Reconnect the wiring.
3.24a Removing a direction indicator side
repeater
3.27 Rear light cluster bulbholder retaining
lugs (arrowed)
3.19 Unhook the spring (arrowed) to
release the front indicator light unit
18 Refit the lens and reflector and secure it
with the two screws. Check for correct
operation.
Front direction indicator
19 From under the bonnet, unhook the spring
which secures the direction indicator light unit
(see illustration).
20 Withdraw the light unit and free the
bulbholder from it by twisting it anti-clockwise
(see illustration).
21 Remove the bulb from the holder by
pushing and twisting anti-clockwise. Fit the
new bulb to the holder, refit the bulb and
holder to the light unit and refit and secure the
light unit.
22 Check the direction indicators for correct
operation.
Direction indicator side repeaters
23 Reach up behind the wing and release the
light unit by squeezing the two release tags
together.
24 Pull the light unit out of the wing. Twist the
bulbholder anti-clockwise to release it. Pull out
the old bulb and press in the new one (see
illustrations).
25 Refit the bulbholder, then insert the light
unit into its hole and press it home.
Rear light cluster
26 Access to rear light cluster bulbs is gained
from within the luggage area. First remove the
3.28 Identification of rear light bulbs
A Reversing light
D Tail light
B Direction indicator
E Rear foglight
C Stop-light
Body electrical system 13•5
3.20 Removing the bulb and holder from
the direction indicator light unit
access cover on the side concerned; on the
right-hand side, also remove the jack.
27 Grasp the bulbholder in the apertures
provided, squeeze the retaining lugs together
and
withdraw
the
bulbholder
illustration).
28 The appropriate bulb(s) can now be
renewed, and the bulbholder refitted (see
illustration).
Number plate light
29 Carefully prise the light unit out of the
bumper with a screwdriver.
30 Twist the light unit and bulbholder anti-
clockwise to separate them (see illustration).
Pull out the wedge base bulb and press in the
new one.
31 Reassemble the light unit and bulbholder,
then push the assembly home.
3.24b Fitting a new side repeater bulb
3.30 Separate the unit to gain access to the
number plate light bulb
(see
13
Advertisement
Table of Contents
