Table of Contents
Advertisement
12•8 Bodywork and fittings
22.1 Three screws (arrowed) secure the
rear edge of the front door trim panel
colour-coded: the blue plug is outermost. On
models with manually-operated windows,
remove the window winder handle, which is
secured by a single screw (see illustration).
4 Remove the two screws located under the
arm-rest. One of these screws will be
accessible through the window switch
aperture (on higher level trim models) when
applicable (see illustrations).
5 Remove the door interior handle surround,
which is retained by a single screw (see
illustration).
6 Remove the triangular trim panel which
covers the door mirror mountings. This trim
panel is secured by a single screw concealed
under a cover (see illustration).
7 Pull the trim panel away from the door at the
top to free the push-in clips, then lift it to free it
from the lower mountings. A certain amount of
22.5 Removing the door handle surround
screw
22.8a Peeling back the rubber sheet
22.3 Prise the cap off the window winder
handle to expose the screw
jerking and thumping may be necessary to
release the clips and mountings.
8 To gain access to the components within
the door it will be necessary to peel back the
foam rubber sheet. This sheet is secured by a
bead of powerful adhesive around its edge,
and some of the door hardware may be riveted
through it. To remove the sheet from around a
riveted fitting, carefully cut it free with a sharp
knife, then glue it back in place afterwards
(see illustrations).
9 Refit by reversing the removal operations.
Rear door
10 Operations are similar to those just
described for the front door. Note that the
interior handle surround is secured by two
screws, one of which is accessible after
removing the ashtray.
22.6 Removing the mirror mounting trim
screw
22.8b Front door with rubber sheet peeled
back
22.4a The two armrest screws (arrowed) -
low level trim
22.4b Access to the screw is through the
window switch aperture
23 Door window glass - removal
and refitting
1 Remove the door interior trim panel as
described in the previous Section. Peel back
the foam rubber sheet.
2 Remove the door weather strip.
Front door
3 Raise and support the window. Undo the
two screws which secure the glass to the
regulator mechanism and lower the glass into
the door.
4 Remove the three screws (one front, two
rear) which secure the window channels (see
illustration).
23.4 One of the front door window channel
screws (A)
Advertisement
Table of Contents
