Table of Contents
Advertisement
17.4 A door lock motor
Securing screws are arrowed
3 Carefully peel away the foam rubber sheet
in the area of the lock motor.
4 Remove the two securing screws, unhook
the motor from the lock operating rod and
disconnect the multi-plug. Remove the motor
(see illustration).
5 A defective lock motor must be renewed.
No spare parts are available.
6 Refit by reversing the removal operations,
then adjust the lock linkage as follows.
7 Move the locking lever to the "unlocked"
position. Slacken the screw which secures the
interior handle/lock lever assembly, push the
assembly forwards as far as it will go and
tighten the screw.
19.2 Seat adjusting motor bolts (arrowed)
19.3 Removing the spade connectors from
the multi-plug
18.2a Make sure that the lever is against
the stop (arrowed) . . .
18 Window operating motor -
removal and refitting
1 Remove the window operating mechanism,
complete with motor.
2 Make sure that the spring is holding the
lever against its stop, then remove the three
bolts and separate the motor from the
operating mechanism (see illustrations).
Caution: Uncontrolled release of the spring
can cause injury and damage.
3 Refit by reversing the removal operations.
Check the operations of the motor before
refitting the door trim panel.
19 Seat adjusting motors -
removal and refitting
Front height and fore-and-aft
motors
1 Move the front seat rearwards as far as
possible to improve access. Remove the two
securing bolts from the front of the seat frame
and tip the seat backwards.
2 Unbolt and remove the motor(s). Each
motor is secured by two bolts
illustration). Make sure that the drive cables
come away from the worm drives without
difficulty - if not, disconnect one end of the
worm drive too.
3 If only one motor is being removed, free its
19.7 Front seat recline motor bolts
(arrowed)
Body electrical system 13•15
18.2b . . . then remove the three bolts
(arrowed) which secure the motor
spade connectors from the common multi-
plug washer removing the plug shell (see
illustration). It is probably easier to remove
both motors and deal with the connectors on
the bench.
4 Refit by reversing the removal operations.
Check for correct operation of the motors on
completion.
Front recline motor
5 Remove the front seat.
6 Remove the seat cover and cushion.
7 Remove the two securing bolts (see
illustration), disconnect the multi-plug and
withdraw the motor from the reclining
mechanism.
8 When refitting, make sure that the motor
pinion gear meshes with the reclining
mechanism gear. Connect the multi-plug and
secure the motor with the two bolts.
9 Refit the seat cover and cushion, then refit
the seat to the vehicle.
Rear recline motor
10 Remove the trim panel from the left-hand
side of the luggage area.
11 Remove the three Torx screws which
secure the motor and reclining mechanism.
(see
Disconnect the multi-plug (next to the seat
squab)
and
remove
illustration).
12 Refit by reversing the removal operations.
Check for correct operation before refitting the
luggage area trim panel.
19.11 Rear seat recline motor
the
motor
(see
13
Advertisement
Table of Contents
