Introduction; Line Setup; Configuring Pppoe; Configuring The G.shdsl Card For Pppoe - Patton electronics SMARTNODE 5400 Getting Started Manual

SmartNode 5400 Getting Started Guide

Introduction

The SN5400 model has an option for a built-in G.SHDSL modem. The modem appears in the configuration
as "port dsl 0 0" mode.
Profile
napt
WAN
CAUTION
Note For information about the specifications of the G.SHDSL daughter card,
see Appendix B,

Line Setup

There is no line modulation setting. The modems automatically adapt to the bit rate and modulation used.
The status LED on the back of the device is blinking while the modem attempts to connect and lit when the
link is established. If the modem keeps blinking, check the cabling,

Configuring PPPoE

Figure 8 explains how to configure PPPoE on the SmartNode's built-in G.SHDSL card. To configure the DSL
port for PPPoE, first you need to log in to the SmartNode via the CLI and enter configuration mode.
login: administrator
password: <enter>
SN4xxx>enable
SN4xxx>#configure

Introduction

vpi 8
session MyISP
Figure 8. Configuring the G.SHDSL card for PPPoE
The Modem setup uses IP messages within its own subnet:
192.0.2.0/24. SmartNodes with built-in modems cannot use this
subnet in any other way.
"Specifications"
5 • G.SHDSL Basic Configuration
port
dsl 0 0
\ \
pvc
vci 35
pppoe
WAN
interface
context
ip
on page 46.
Subscriber PPP
MySubscriber
37