Hangar 9 fokker D.VII Assembly Manual page 30

o
Step 11
Slide the wheel backplate onto the landing gear wire. Slide
a wheel collar over the axle. Make sure the wheel collar is
no more than 9/16-inch (15mm) from the end of the axle
or the wheel may not rotate freely due to the axle hitting
against the wall of the outside rim half. Use a 1.5mm hex
wrench to tighten the setscrew.
Wheel Collar
Important: Make sure to use
threadlock on the screws to prevent
them from vibrating loose.
30
9/16-inch (15mm) maximum
Axle
o
Step 12
Replace the tire and wheel front plate. Use the screws
remove from Step 10 to rebuild the wheel.

Step 13
Repeat Steps 10 through 12 to install the remaining wheel.