Hangar 9 fokker D.VII Assembly Manual page 38


Step 8
Secure the throttle servo in the fuselage using the
hardware provided with the servo.

Step 9
Enlarge the hole 1/2-inch (13mm) from the center of the
servo horn using a 5/64-inch (2mm) drill bit. Use side
cutters to remove any unused arms from the horn. Slide
the pushrod connector into the hole.
38

Step 10
Secure the connector using the connector backplate.

Step 11
Center the throttle servo using the radio system. Install the
arm perpendicular to the servo center line.