SmartLink 4020 Getting Started Guide
Routing
These configuration parameters are for the internal router.
Note
These parameters only apply when the Device Operating Mode is set to Router
(see section
Dynamic Routing
Whether or not dynamic routing on the interfaces is enabled/disabled.
Static Routing
Under Static Routing, you can specify the routing paths of your internal network.
Viewing the Routing Table
Click the
View Routing Table
Saving your work
When you are finished configuring Router settings, click the
page 41) to save the changes.
Routing
"Device Operating Mode"
Figure 17. Router Configuration window
button to display the Routing Table (see
Figure 18. Routing Table window
on page 32).
figure
18).
Save Router Settings
5 • Network—LAN
button (see
figure 17
on
41