Call Forward All; Ip Dialing; Call Hold; Call Waiting (Call Alternative) - Patton electronics 4020 Series Getting Started Manual

SmartLink 4020 Getting Started Guide 7 • System
*7123019751000 and on-hook the phone. When 2 is pressed on the telephone key pad, 3019751000 will
be called.

Call Forward All

Configures the number to unconditionally forward all calls to. To configure call forward all enter the calling
prefix key (*73 is the factory default), the number to dial and then on hook the phone. You will hear a second
dial tone after entering the calling prefix key. Before using, Call Forward All must be enabled using the activate
sequence defined in the supplementary service table.
Example:
*733019751000 and on-hook the phone. All calls received will forward to 3019751000.

IP Dialing

Allows direct calling using an IP address. To use calling by IP address enter the calling prefix key (*72 is the fac-
tory default), the * key, the IP address using the * key to between octets of the IP address, the * key and the
port number. You will hear a second dial tone after entering the calling prefix key. Before using direct IP
address dialing must be enabled using the activate sequence defined in the supplementary service table.
Example:
To place a call to IP address 192.168.1.20:5061 enter *73*192*168*1*20*5060.

Call Hold

Configures the key sequence to place a call on call on hold – The factory default is flash hook 1.

Call Waiting (call alternative)

Configures the key sequence to switch between calls. The factory default is flash hook *.

Call Conference

Configures the key sequence to conference two calls together. The factory default is flash hook 7.

Call Conference Drop

Configures the key sequence to drop the last call that was added to the conference the conference. The factory
default is flash hook 8.

Call Transfer

Configures the key sequence for call transfer. The factory default is flash hook 4.

Voicemail access

Configures the key sequence for call for voicemail access. The factory default is flash hook *86. If the voicemail
key sequence is entered on the phone a call will automatically be placed to the configured service provider
using the configured authentication information.

Call Forward Busy Destination

Configures the number to forward calls to when busy. To configure call forward busy enter the calling prefix
key (*74 is the factory default), the number to dial and then on hook the phone. You will hear a second dial
Localization 73