Qos (Quality Of Service); Enable Voice Qos; Assured Bandwidth For Voice; Maximum Uplink Bandwidth Allowed - Patton electronics 4020 Series Getting Started Manual

SmartLink 4020 Getting Started Guide 4 • Network—WAN

QoS (Quality of Service)

Figure 12. QoS window

Enable Voice QoS

Enable or disable the voice quality of service function. When QoS is enabled, the SmartLink 4020 will priori-
tize and rate-limit the introduction of voice and data traffic onto the WAN interface.

Assured Bandwidth for Voice

This parameter defines the guaranteed bandwidth for voice traffic on the WAN interface (in kbits/sec).

Maximum Uplink Bandwidth Allowed

The maximum uplink bandwidth that can be allocated to voice traffic.

Saving your work

When you are finished configuring settings, click the button to save the changes.
Save Settings

ToS/DiffServ

This sub-page is used to configure the Type-of-Service/Diffserv byte values which are to be used in the IP
header of all transmitted SIP signaling packets and RTP packets. The ToS/DiffServ byte values are entered as
two-digit hexadecimal values. If no special ToS/DiffServ value is to be used for a particular traffic type, enter 00
or leave the setting empty.
Figure 13. TOS/DiffServ window
QoS (Quality of Service) 36