Table of Contents
Advertisement
2.7
Handling
Once you have removed the packaging, pro-
ceed as follows to handle the boiler:
- remove the screws securing the boiler to
the wooden pallet
- remove the front panel (P) and top panel (C)
from the casing (fig. 2.5)
Fig. 2.5
- unscrew the nut (A) from the top front
tie-rod(fig. 2.6)
- fit one of the lifting plates (B) over the end
of the tie-rod (C) (fig. 2.6)
- screw the nut (A) back on (fig. 2.6)
Fig. 2.6
- unscrew the nut (D) from the top rear tie-
rod (fig. 2.7)
- fit the second lifting plate (E) over the end
of the tie-rod (F). Make sure that the sec-
ond lifting plate is diagonally opposite that
fitted previously (fig. 2.7)
- screw the nut (D) back on (fig. 2.7)
Fig. 2.7
- lift the boiler using a 1" pipe (G) inserted
through the two lifting plates (fig. 2.8)
- once the boiler is in its final installation
position, reverse the above steps to remove
the two lifting plates. Securely tighten the
nuts.
b
Wear suitable personal protective equip-
ment and use suitable safety devices.
Fig. 2.8
9
Hide quick links:
Advertisement
Table of Contents
