Flashforge Creator Pro User Manual page 28

● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower speed is, the better
print you will get. For PLA printing, 80 is recommended.
b. Support Print Speed is needed to set when choosing Slic3r as the
slice engine which can control the moving speed of the extruder when printing the supports.
c. Travel Speed is to control the moving speed of the extruder under non-printing Status
during work. for PLA printing, 100 is recommended.
Note: Modify parameters settings to get better prints as different models need different parameters.
● Temperature
Extruder Temperature: Recommended extruder temperature is 220℃.
Note: Different temperatures have subtle influences in prints. Please adjust the temperature
according to the condition in order to get a good print.
● Others
Pause At Heights: Allows users to pre-set a height in which the print will suspend
automatically. The function usually applied when you want to change the filament at a certain point.
(5-7) Click[Edit], then you can add or remove a height.
5.1.11 File Menus
①New Project
Click [File]--[New Project]
5-7
can build a blank project. If there is an unsaved modification on
28