Chapter 5: About Software; Software Installation; Exploring Flashprint - Flashforge Creator Pro User Manual

Chapter 5: About Software

5.1 Software Installation

5.1.1 Software Acquisition
Method 1: To get the installation package from the SD card in the toolkit.
Method 2: Open the link below to download the installation package:
http://www.ff3dp.com
Steps: Support---Downloads---Creator Pro FDM 3D Printer
5.1.2 Software Installation and Start-up
1. Decompress the zipped file or start the installation program, and then install the software
according to the direction.
2. Start the software with the start menu shortcut or by clicking the software icon.(See 5-1)
5-1

5.2 Exploring FlashPrint

Note：Before updating Firmware, you need to install a relevant drive (As for the details, please
refer to 5.2.13.1 Update Firmware).
5. 2.1 Machine Type Selection
! After starting FlashPrint, you need to select the target machine type first.
When you start FlashPrint, a dialog box will pop up. Just need to select Flashforge Creator Pro in
the machine type list and click [OK]. You can also change the machine type via clicking [Print]--
[Machine type]. Please see graphic 5-2:
16