Flashforge Creator Pro User Manual page 39

▶Start Preheating
Right Extruder
Left Extruder
Platform
4) Press page up key
Heating:
R Extruder: 033/230C
L Extruder: 033/230C
Platform: 024
This means the left extruder is heating up, when it reaches 220°C. First
bit until you see filament come out of the
have withdrawn the filament inside the nozzle successfully.
(4) properly level the build plate.
Every printer will be leveled before shipped out, but we can't ensure that the platform won't move
during delivery, so it will be better to level platform before you begin to print. We should tighten the
three knobs under the build platform, then put one SD card within the 3D printer， there is a file
named PlateLeveling.x3g.Put the SD card into the slot,choose
choose PlateLeveling.x3gand click it, you will see the content
build platform and tighten four or five turns. Nozzles are at the right height when you can
just slide a sheet of paper between the nozzle and the plate. Grab a sheet of paper to assist us.
Please wait. (During the process, what you should do is only click OK continuously, the screen will
go to next page.)
(1) Then the build plate and the nozzle start moving, once they suspend, you need to adjust the
corresponding knob under the build plate individually. Use the leveling card or a thin piece of paper
to check the distance between the build plate and the nozzles.
(2).As you adjust the knob, make sure the leveling card just slides between the nozzle and build
plate. You should feel some friction on the card but still be able to easily pass the card between the
nozzle and build plate.
(3) When you finish leveling the first point, you should repeat the steps above to finish leveling the
rest three points.
How to Level the Build Plate
ON
ON
OFF
back to Start Preheat, and Press
nozzle,
OK key, you will see:
pull it out
then
Print from SD
below:Find the 3 knobs under the
39
push in the filament
quickly. This will ensure you
,click OK,then
a little