Flashforge Creator Pro User Manual page 38

Unload Right
Load Left
Unload Left
5. Select the appropriate side of the extruder you wish to load(Left or Right for models with
dual extruders). Press the
heating up my extruder!" At this time, the temperature of the right nozzle is being heated up.
When the temperature of the nozzle reaches its target temperature, pressing the
the keypad, and the nozzle should start extruding material. If not, keep pressing the
unit it does.
Withdrawing the Filament Using LCD Screen
CAUTION
If you just finished your printing or already extruded the filament and want to withdraw the filament, at this
moment, the extruder is still over 200°C, first push the filament in a little further, and then directly pull it out.
If you want to change another color filament, first you need to withdraw filament and then load in. Please
do as following shown to avoid filament jam.
1) Turn on the Creator Pro, the display will indicate:
Build from SD
▶ Preheat
Utilities
2) Using the directional arrows to the right of the screen, press
next page and select Preheat, Press
▶ Start Preheating
Right Extruder
Left Extruder
Platform
page down key
3) Press
see：
OK key again on the keypad. The display will indicate: I'm
OK key on the keypad, then you will see：
OFF
OFF
OFF
Left Extruder (or Right
to select
38
page down key
Extruder), click OK
OK key on
OK key
to scroll to the
key, you will