To Recall Waterfall And Spectrogram Displays - Agilent Technologies 89410A Operator's Manual

Using Waterfall and Spectrogram Displays (Opt. AYB)

To recall waterfall and spectrogram displays

This procedure shows you how to recall waterfall and spectrogram
displays. See the previous procedure for instructions on saving waterfall
and spectrogram displays.
1.
Activate the trace where you want the waterfall or spectrogram display. For
example, if you want to display a waterfall display in trace A, press [A].
2.
Turn on the waterfall or spectrogram display.
Press [ ] [
Display waterfall setup
OR
Press [ ] [
spectrogram setup
Display
3.
If the trace buffer is in a file, recall the trace buffer from the file into a data
register (if the trace buffer is in a data register, skip this step):
Press [ ], [
Save/Recall
Cho ose a file and data register.
4.
Display the data register:
Press [
Measurement Data
Choose the desired data register.
Any trace buffer may be recalled as either a spectrogram or a waterfall,
regardless of which display was selected at the time the buffer was stored.
If the data register contains only one trace, then the waterfall or
spectrogram only displays the single scan.
7 - 16
] [ ].
waterfall on
] [
spectrogram on].
], [ ].
recall more recall trace buffer
], [ ]
data reg