Fault Inputs 1 - 8 - Siemens Synco living Operating Instructions Manual

Hide thumbs Also See for Synco living:
Table of Contents

Advertisement

With the softkeys defined as info pages, you can select the info pages that
should be displayed when pressing the keys.
Main menu > Settings > Info page selection > Info page button 1A:
Main menu > Settings > Info page selection > Info page button 1B:
Main menu > Settings > Info page selection > Info page button 2A:
Main menu > Settings > Info page selection > Info page button 2B:
Main menu > Settings > Info page selection > Info page button 3A:
Main menu > Settings > Info page selection > Info page button 3B:
Main menu > Settings > Info page selection > Info page button 4A:
Main menu > Settings > Info page selection > Info page button 4B:
Faults

Fault inputs 1 - 8

Faults of external plant components can be communicated to the central
apartment unit by closing a contact. There are 8 fault inputs available.
The fault inputs must have been activated when commissioning the
plant, and the required input must be connected to the central apart-
ment unit so that the settings described here can be made. For the
relevant descriptions, refer to document "Mounting and Commissioning
(CE1C2707en)".
For each fault input, following can be selected or set:
• Fault text (text that should be displayed at the respective fault input when
the fault occurs)
• Fault priority (urgent or Not urgent)
• Fault release (always or only during absence)
• Fault status message delay (time span 00.00..60.00 ms, until a pending
fault generates a fault status message)
• Normal position: It can be selected here whether an open or closed contact
should be used to indicate a faulty condition.
Normally open means that an open contact is considered to indicate "nor-
mal operation"
76 / 100
Siemens
Building Technologies
Synco™ living Operating instructions
Central apartment unit QAX910
CE1B2707en
23.08.2008

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents