Traps: Enterprise-Specific - Paradyne 9820 User Manual

SNMP MIBs and Traps, and RMON Alarm Defaults

Traps: enterprise-Specific

B-12
These traps indicate that an enterprise-specific event has occurred. Supported
enterprise-specific traps are listed below.
Table B-8. enterprise-Specific Traps and Variable-Bindings (1 of 2)
Trap Variable-Bindings
enterpriseCIR-
Change(15)
enterpriseConfig-
Change(6)
enterpriseDLCI-
delete(17)
enterpriseDLCI-
Down(11)
enterpriseDLCIUp(12)
enterpriseLinkSpeed-
Change(14)
June 2000
devFrExtDlciIfIndex
(devFrExt.mib)
devFrExtDlciDlci
(devFrExt.mib)
devFrExtDlciCIR
(devFrExt.mib)
devLastTrapString
(devHealthAndStatus.-
mib)
devLastTrapString
(devHealthAndStatus.-
mib)
devFrExtDlciIfIndex
(devFrExt.mib)
devFrExtDlciDlci
(devFrExt.mib)
devLastTrapString
(devHealthAndStatus.- (devHealthAndStatus.-
mib.)
ifIndex (RFC 1573)
ifSpeed (RFC 1573)
devLastTrapString
(devHealthAndStatus.-
mib
Possible Cause
CIR has changed due to the LMI
report. LMI Protocol is set to
Standard and the network's CIR
changed.
String:
'CIR on $ifString changed to
$CIR bps.'
Configuration has been changed
via the menu-driven user
interface, an SNMP Manager,
or auto-configuration after 60
seconds has elapsed without
another change.
String:
'Device configuration change.'
The DLCI has been deleted. The
network no longer supports the
DLCI, and it was removed.
Strings:
'$ifString deleted by Auto-DLCI
delete.'
DLCI Status is set to Inactive; the
DLCI is down.
Strings:
'$ifString down.' (Due to LMI or
physical failure.)
'$ifString administratively
shutdown.' (Due to an intentional
shutdown.)
DLCI Status is set to Active;
DLCI is up again.
String:
'$ifString up.'
Speed has changed as a result
the Autorate algorithm.
String:
'Speed of $ifName changed to
$ifSpeed bps.'
9820-A2-GB20-20