Device Messages - Paradyne 9820 User Manual

Device Messages

9820-A2-GB20-20
These messages appear in the messages area at the bottom of the screens.
All device messages are listed in alphabetical order.
Table 6-9. Device Messages (1 of 5)
Message What It Indicates
Access level is n , The user's access level is 2
Configuration is or 3; the user is not
Read-only. authorized to change
configurations.
Already Active The test selected is already
running.
Cannot Modify TS The Management PVC you
Management Link are attempting to modify is
defined as the TS
Management Link.
Cannot save - no You are attempting to save
Level 1 Login IDs a configuration which has
no Level 1 Login ID.
Command Complete Configuration has been
saved or all tests have
been aborted.
Connection Refused Two menu-driven user
interface sessions are
already in use when a
Telnet session was
attempted.
DLCI in connection. You tried to delete a DLCI
Delete connection first that was part of a
connection.
DLCI Number Already The number entered is a
Exists duplicate of an existing
DLCI record.
DLCI Number The number entered is a
Reserved special excluded DLCI in
the product.
File Transfer Complete A file transfer was
performed successfully.
(Seen at an FTP
terminal.)
June 2000
Monitoring
What To Do
No action needed.
Allow test to continue.
Select another test.
Stop the test.
No action needed.
Modify a different PVC.
Create a Login ID with an access
level of 1, then save the
configuration.
No action needed.
Wait and try again.
No action needed, or
Delete the connection, then
delete the DLCI.
Enter another DLCI number.
Enter another DLCI number.
Switch to the newly downloaded
software.
See Changing Software in
Chapter 7, FTP Operation .
6-11