Limiting Ftp Access - Paradyne 9820 User Manual

Security and Logins

Limiting FTP Access

5-6
FTP access can be limited by:
Disabling FTP access completely.
Requiring a user ID and password to login.
Limiting FTP bandwidth. (Models 9820, 9820-2M, 9820-8M.)
Procedure
To limit FTP access when the session is not on the TS Management Link:
1. Select the Telnet and FTP Session options.
Main Menu Configuration
Telnet and FTP Sessions
2. Set the following configuration options, as appropriate.
To . . .
Disable FTP
Require a login
Limit bandwidth for FTP
(Models 9820, 9820-2M, 9820-8M)
3. Save your changes.
Configuring Telnet and/or FTP Session Support
See
Options, for more information about setting FTP configuration options.
June 2000
Management and Communication
Set the configuration option . . .
FTP Session to Disable.
Login Required to Enable.
NOTE: User ID and password combinations
must be defined. See Creating a Login
If you want to allow users to configure the unit
or perform file transfers, including downloads,
keep the access at Level-1.
Level-1 access is required to download
software to the unit, or to upload or download
configuration files. Level-3 is sufficient for
NMS access for SLV historical information.
FTP Max Receive Rate to a rate less than the
network line speed, typically less than or
equal to the CIR.
T
his method is not recommended if SLV
reports are desired since FTP is required to
generate the reports.
in Chapter 4, Configuration
.
9820-A2-GB20-20