Removing A Blank Panel - HP A6604 Installation Manual

Figure 4-48 Blank panel for a HIM/MIM slot
(1) Front view
(3) Oblique rear view
Figure 4-49 Blank panel for a power module slot
(1) Front view
(3) Oblique rear view

Removing a Blank Panel

Removing a Blank Panel
Follow these steps to remove a blank panel: Follow these steps to remove a blank panel:
Step1 Face the front panel of the router. Face the front panel of the router.
Step2 Locate the blank panel to be removed: Locate the blank panel to be removed:
For an RPE-X1, FIP, power, or HIM blank panel, loosen the two captive screws

counterclockwise with a Philips screwdriver until all spring pressure is released. Then, remove counterclockwise with a Philips screwdriver until all spring pressure is released. Then, remove counterclockwise with a Philips screwdriver until all spring pressure is released. Then, remove
the blank panel.
For a HIM/MIM blank panel, loosen the four fastening s For a HIM/MIM blank panel, loosen the four fastening screws counterclockwise with a Philips

driver. Then, remove the blank panel. driver. Then, remove the blank panel.
Step3 The following figure illustrates how to remove a FIP blank panel. The following figure illustrates how to remove a FIP blank panel.
Blank panel for a HIM/MIM slot
Blank panel for a power module slot
X1, FIP, power, or HIM blank panel, loosen the two captive screws X1, FIP, power, or HIM blank panel, loosen the two captive screws
(2) Side view
(4) EMI gasket
(2) Side view
(4) EMI gasket
crews counterclockwise with a Philips