Loop Protection - i3 International S241 User Manual

Loop Protection

Using Loop Protection page to configure loop protection
LOCATION：Configuration>Loop Protection
Parameters:
Items
General Settings
Enable Loop Protection
Transmission Time
Shutdown Time
Port Configuration
Port
Enable
Action
Tx mode
WEB Interface:
To Configure the Loop Protection：
A. Click
B. Enable Loop Protection, configure Transmission Time and Shutdown Time
C. Specify reaction for each port when loop protection is detected
D. Click Save to apply the setting or Reset to restore the previous setting.
Description
Controls whether loop protections is enabled
The interval between each loop protection PDU sent on each port. Valid values are 1 to
10 seconds
The period(in seconds) for which a port will be kept disabled in the event of loop is
detected (and the port action shuts down the port). Valid values are 0 to 604800
seconds(7 days). A value of zero will keep a port disabled (until next device restart)
Port identifier
Control whether loop protection is enabled on this switch port
Configure the action performed when a loop protection is detected on a port. Valid values
are "Shutdown Port", "Shutdown Port and Log", or "Log only"
Control whether the port is actively generating loop protection PDU's, or whether it is just
passively looking for looped PDU's
Configuration/Loop Protection
54