Security/Switch/Snmp/System - i3 International S241 User Manual

Security/Switch/SNMP/System

Using the SNMP System Configuration page to configure SNMP settings, Community name, trap host and public traps as
well as the throttle of SNMP, A SNMP manager must pass the authentication by identifying both community names, then it
can access the MIB information of the switch. So, both parties must have the same community name.
LOCATION：Configuration>Security>Switch>SNMP>System
Parameters:
Items
SNMP System Configuration
Mode
Version
Read Community
Write Community
Engine ID
SNMP Trap Configuration
Trap Mode
Trap Version
Trap Community
Trap Destination Address
Trap Authentication Failure
Trap Link-up and Link-down
Trap Inform Mode
Trap Inform Timeout
Trap Inform Retry Times
Trap Probe Security Engine ID
Trap Security Engine ID
Trap Security Name
WEB Interface:
Configuration/Security/Switch/SNMP/System
A. Click
B. Set Mode to Enable SNMP service and specify SNMP version then change the Read and Write Community access
strings if required and set the engine ID
C. In the SNMP Trap Configuration table, enable Trap mode to allow the switch to send SNMP traps. Specifies the
trap version, trap community and IP Address of management PC/NB which will receive the trap messages.
Select inform mode for SNMP v2c and SNMP v3 clients. Set Security engine ID for SNMP v3 client.
Description
Enables or disables SNMP service
Specifies the SNMP version (SNMP v1, SNMP v2c, SNMP v3)
The community for Read access
The community for Read/Write access
The SNMP v3 Engine ID,It is only available for SNMP v3 (10-64 HEX digits,
excluding a string of all 0's or F's)
Enables or disables SNMP traps
Specifies the Trap Version (SNMP v1, SNMP v2c, SNMP v3)
Specifies the community string for SNMP trap packets
Specifies the IP Address of management PC/NB to get trap packets
Issues a notification message to specified IP trap managers whenever of a SNMP
request fails.
Issues a notification message to specified IP trap managers whenever a port
link is established or broken
Enables or disables sending notification as inform message. It is only available for
SNMP v2c and SNMP v3. Inform mode can guarantee the message is received.
The time for waiting a ACK (Range：0-2147, unit：second)
The Maximum numbers of re-try times before gotting ACK
Specifies whether or not to use the engine ID of the SNMP trap probe in trap and
inform messages(It is only available for SNMP v3)
Displays the SNMP Trap security engine ID. (It is only available for SNMP v3)
Displays the Trap security Name (It is only available for SNMP v3)
27